Mitsubishi MR-508XL Dokumentacja Pobierz pdf (Strona 20)

7.20

Bimba Position Feedback Cylinder Accessories

Engineering Specifications

Repeatability: ±0.001" Cylinder Only.

Refer to specifications in the following sections for positioning or

measuring repeatability. Power supply ripple and A/D error may reduce

repeatability when PFC is utilized with industrial control systems.

Nonlinearity: ± 1 percent of full stroke

Resolution: Infinite

Signal Input: 10 VDC typical

Input Impedance Required: 1 MOhm

Signal Output: > 0 to slightly less than FS signal input

(The internal electrical stroke is slightly larger than the

mechanical stroke of cylinder)

Maximum Speed: 25 in./sec.

Rated Life of LRT Wiper: 1,000

miles of travel

Rated Life of Probe: 10 million cycles

Air Requirements: Filtered to 5 micron with 0 degree dewpoint recommended.

Moisture inside cylinder will cause output signal fluctuation.

Pressure Rating: 150 psi

Temperature Rating: 0° to 200°F

Interface: 6" standard leads or optional 8mm DIN connector

Cylinder Body: 304 stainless steel

Piston Rod: Hard chrome plated carbon steel with blackened

threads and wrench flats

Rod Bushing: Sintered bronze

End Caps: Anodized aluminum alloy

Piston Seal: Internally lubricated urethane (standard)

Internally lubricated Buna (L option)

Rod Wiper: Internally lubricated Buna N (omitted on L option)

Rod Seal: Internally lubricated Buna N (N/A on standard model)

Higher velocities increase wear rate.

Special low temperature lubrication is required for positioning applications using option L seals below 35°F.

ESTIMATED CYLINDER WEIGHTS (LBS)

1-1/16" 1-1/2" 2 2-1/2" 3

PFC- 0.44 0.88 2.02 2.78 3.62

PFC-X 0.49 0.96 2.14 2.96 3.85

PFC-BF 0.54 1.07 2.28 3.02 4.08

ADDER WT/IN 0.06 0.10 0.15 0.20 0.29

Repair Parts

PART DESCRIPTION

RPFC-Bore Stroke-Options*

Replacement Cylinder

RD-53129-Stroke-Options**

Replacement Probe

• Blank - no connector

• P - replacement corded connector**

• PA - non-corded with connector**

* Only options required are BF, B, and L as Rear Cap is not included.

** Select option for type of probe.

How to Order

Add the bore size, stroke and options needed to the basic

model number shown above for replacement cylinder.

Add the stroke length to the basic model number shown

above for a replacement probe. For example, a replacement

probe for a 6" stroke Position Feedback Cylinder would be

ordered as a RD-53129-6.

LRT CIRCUIT DIAGRAM

STROKE = 0; OUTPUT VOLTAGE = 0 VOLTS

STROKE = FULL; OUTPUT VOLTAGE = 10 VOL

OUTPUT

(WHITE)

+10

(RED)

GROUND

(BLACK)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

Komentarze do niniejszej Instrukcji

Brak uwag

Mitsubishi MR-508XL Dokumentacja Strona 20

Komentarze do niniejszej Instrukcji