Mitsubishi MR-508XL Dokumentacja Pobierz pdf (Strona 47)

7.47

For Technical Assistance: 800-442-4622

Bimba Digital Panel Meter

Position Feedback

Cylinders

Position Feedback

Cylinder Non-Contact

Position Feedback

Cylinder Rod Lock

Position Feedback

Cylinder Accessories

Position Feedback

Pneu-Turn

Position

Control System

Digital Panel Meter Electronic Controller

PFC/PCS/PTF

Application Checklist

Basic Connections

Parameter Lock Mode

A user input can be used to lock the parameter list.

When the user input is active, the meter is in the

protected parameter mode, where it is only possible

to access the setpoint values and the security code.

It is possible to lock the parameter list without using

a user input as a program lock function. In this case,

set the security code to a non-zero value. With a

non-zero security value set, press the PAR Key to

view the programmed setpoint values. The security

code requires a “key” value to gain access to the

full parameter list.

Installation

The DPM meets NEMA 4X/IP65 requirements for indoor use when properly installed. The unit is intended to

be mounted into an enclosed panel. Prepare the panel cutout to the dimensions shown in the Dimensions

drawing. Remove the panel latch and cardboard sleeve from the unit and discard the cardboard sleeve.

Slide the panel gasket over the rear of the unit to the back of the bezel. The unit should be installed fully

assembled. Insert the unit into the panel cutout. While holding the unit in place, push the panel latch over the

rear of the unit so that the tabs of the panel latch engage in the slots on the case. The panel latch should be

engaged in the farthest forward slot possible. To achieve a proper seal, tighten the latch screws evenly until

the unit is snug in the panel (Torque to approximately 7 in-lbs [79N-cm]). Do not over-tighten the screws.

Ordering Information

All product is sold F.O.B. shipping point. Prices are subject to change without notice.

Model Number Description List Prices

DPM Base Unit - Includes Excitation, Quad Solid State Outputs $539.15

DPMA Base Unit with Analog Card 650.85

DPMR Base Unit with Quad Form A 120VAC Relay 631.20

DPMS Base Unit with RS-485 Serial Output 631.20

DPM-485 RS-485 Plug-In Accessory Card 92.15

DPM-232 RS-232 Plug-In Accessory Card 92.15

DPM-DNET DeviceNet Plug-In Accessory Card 223.60

DPM-A Analog Plug-In Accessory Card 144.70

DPM-R Quad From A 120 VAC Relay Plug-In Accessory Card 92.15

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53

Komentarze do niniejszej Instrukcji

Brak uwag

Mitsubishi MR-508XL Dokumentacja Strona 47

Komentarze do niniejszej Instrukcji